Installation Details - Sanden EcoPlus GAUS-300FQS Owner's Manual

Installation details

This EcoPlus Hot Water Heat Pump System must be installed by an EcoPlus authorized
technician in consideration of the following standards and regulations:
Clauses G12 & H1 of the New Zealand Building Code

AS/NZS3500 National plumbing and drainage code hot water supply systems

– acceptable solutions
AS/NZS 3000 Electrical installations (known as the Australian/New Zealand wiring

rules)
The unit has been specifically designed for domestic hot water heating and is not

suitable for any other purpose.
The unit is designed to operate when connected to the town water supply with a

maximum operating pressure of 500 kPa. To ensure the mains pressure does not
exceed this, a pressure-limiting device that complies with AS1357 must be
connected to the town water supply line.
This system delivers hot water exceeding 55

AS/NZ3500 and/or local regulations relating to the need for temperature tempering
devices.
The unit must be stored and transported in an upright position. Failure to do so may

render the unit faulty. Such failure is not covered under any warranty agreements.
Failure to comply with the above conditions will void the warranty.
SAFE TRAY AND SEISMIC RESTRAINTS
The water heater must be installed with a properly drained safe tray where there is the
possibility of water damage to furniture, carpets or building. All water heaters must be
restrained to protect against seismic forces (refer to the NZ Building Code for
acceptable solutions).
Figure 2: Typical installation layout
The water heater must be installed and serviced by an EcoPlus authorized installer and the installation must comply with the New Zealand Building Code G12, Supplied
Installations Instructions, AS/NZS 3000 Electrical Installations and all local codes and regulatory authority requirements.
Sanden Heat Pump – Owner's Manual
Page 8 of 20
C. Reference should be made to
o