How To Connect Power Line And Thermistor Cable - Sanden GAUS-160FQS Owner's Manual

How to connect power line and thermistor cable

Please note：
Electrical installation should only be done by a licensed electrician
Remove the piping cover screw clamp fitting.
Connect the power supply line to the terminal block.
Hold the power supply line below the terminal block with the screw clamp fitting.
Connect the thermistor cable line to the terminal block.
Hold the thermistor cable with the code clip and conduit clip
Attach the piping cover back on the heat pump unit.
Figure 6: Connect power cables
25mm or less
Sanden Heat Pump – Owner's Manual
Page 13 of 20