Table of Contents
Advertisement
About your projector
Remote control
1 Power <v/b> button (v standby / b power on)
Sets the projector to the state where the projector is
switched off (standby mode). Also starts projection when
the power is switched off (standby mode).
2 Input selection buttons (<COMPUTER 1> /
<COMPUTER 2> / <HDMI> / <VIDEO> / <MEMORY
VIEWER/USB DISPLAY/NETWORK>)
Switches the input signal to project. (x page 39)
3 <ENTER> button/asqw buttons
Used to navigate through the menu screen.
4 <MENU> button
Displays or hides the main menu. (x page 48)
When the sub menu is displayed, pressing it will return to
the previous screen.
5 <ASPECT> button
Switches the aspect ratio of the image.
6 <FREEZE> button
Pauses the projected image and mute the audio
temporarily. (x page 44)
7 <AV MUTE> button
Used to turn off the audio and video temporarily.
(x page 44)
8 <D.ZOOM +/-> buttons
Zoom in and out the images. (x page 45)
9 <VOLUME +/-> buttons
Adjusts the volume of the built-in speaker or audio
output. (x page 45)
Attention
f Do not drop the remote control.
f Avoid contact with liquids.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on
the back of the remote control unit (see the right picture).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
22 - ENGLISH
Chapter 1 Preparation - About your projector
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
10 Remote control signal emitter
11 <AUTO SETUP> button
Executes Input search, Auto PC adj. and Auto Keystone
correction at the same time.(x page 42)
12 <INFO.> button
Displays the status of the projector. (x page 76)
13 <KEYSTONE> button
Corrects the distortion of the projected image.
(x page 43)
14 <LAMP> button
Switches the settings of [Lamp control].
( Æ pages 44, 58)
15 <P-TIMER> button
Operate the P-timer function. (x page 44)
16 <IMAGE> button
Switches the image mode. (x pages 45, 55)
17 <DAYLIGHT VIEW> button
Used to correct the image when the projector is used in a
bright surroundings. (x pages 46, 57)
18 <MUTE> button
Used when temporarily turning off the audio.
(x page 45)
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
Caution label at the back of the remote control
1. 请勿把旧电池和新电池一起使用。
Made in China
Advertisement
Table of Contents
