Making A Call - Sony WI-C600N Help Manual

Help Guide
Wireless Noise Canceling Stereo Headset
WI-C600N

Making a call

You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free
Profile) or HSP (Headset Profile), via a Bluetooth connection.
If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
The operation may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied
with your smartphone or mobile phone.
The headset only supports normal incoming calls. Calling apps for smartphones and computers are not supported.
Connect the headset to a smartphone or mobile phone beforehand.
1
Operate your smartphone or mobile phone to make a call.
2
When you make a call, the dial tone is heard from the headset.
If you make a call while you are listening to music, playback pauses.
If no dial tone is heard via the headset, switch the call device to the headset using your smartphone or mobile
phone or by holding the
A: Microphones
Used together with the noise canceling function microphone.
Press the + or - button to adjust the volume.
3
When the volume reaches the maximum or minimum, an alarm sounds.
To end the call, press the
4
If you made a call during music playback, music playback resumes automatically after ending the call.
Hint
Volume for a call can be adjusted during a telephone conversation only.
The headset volume during a call and during music playback can be independently adjusted. Changing the call volume does not
change the volume of music playback and vice versa.
Note
Use a smartphone or mobile phone at least 50 cm away from the headset. Noise may result if the smartphone or mobile phone is
too close to the headset.
button down for about 2 seconds.
button on the headset again.
90