Memory Configuration - Siemens SIMATIC IPC227G Operating Instructions Manual

Configure firmware
2.4 "Advanced" tab
Firmware setting
• PCIe Max Link Speed
M.2 Port 3 (X102 / X103)
• SATA Controller(s)
• Serial ATA Port 0
• PCIE bus:devic:function
• PCIe Express Port
Enable
• PCIe Max Link Speed
：For IPC227G or IPC277G, the Firmware setting is "M.2 Port 3 (X102)"; but for IPC327G or
1
IPC377G, the Firmware setting is "M.2 Port 3 (X103)".
2.4.7

"Memory Configuration"

Configure of the memory.
Calling "Memory Configuration"
Select: "Setup Utility (Page 11)" > "Advanced" > "Memory Configuration".
Firmware setting
In-Band ECC
The following options show only when "In-Band ECC" = Enabled.
In-Band ECC Operation
•
Mode
• IBECC Protect Region 0
18
Value Setting in delivery
state
Auto x
Gen1
Gen2
Gen3
1
Enabled x
Disabled
[Empty]/[Seri
al ATA Port 0
TOSHIBA...]
Software
Preserve
Present
Not Present
Enabled x
Disabled
Auto x
Gen1
Gen2
Gen3
Value Setting in delivery state Meaning
IPC227G
IPC277G
Enabled
Disabled x
0 x
1
Enabled
Disabled x
Meaning
x Maximum possible link speed.
The link speed is limited to GEN 1.
The link speed is limited to GEN 2.
The link speed is limited to GEN 3.
Configure the M.2 Port 3
x The SATA port is enabled.
The SATA port is disabled.
Show the SSD information which is read from SSD.
The PCIE bus device function is present.
The PCIE bus device function is not present.
x The PCIe Express Port is enabled.
The PCIe Express Port is disabled.
x Maximum possible link speed.
The link speed is limited to GEN 1.
The link speed is limited to GEN 2.
The link speed is limited to GEN 3.
IPC327G
IPC377G
In-Band ECC(Error Correction Code) is enabled.
x In-Band ECC is disabled.
x Functional mode protects requests based on the
address range.
Makes all request protected and ignore range
checks.
In-Band ECC for Region 0 is enabled.
x In-Band ECC for Region 0 is disabled.
Firmware/BIOS description SIMATIC IPC227G, IPC277G, IPC327G, IPC377G
Operating Instructions, 09/2021, A5E50059883-AB