Memory Configuration - Siemens SIMATIC IPC227G Operating Instructions Manual

2.4.7

"Memory Configuration"

Configure of the memory.
Calling "Memory Configuration"
Select: "Setup Utility (Page 9)" > "Advanced" > "Memory Configuration".
Firmware setting
In-Band ECC
The following options show only when "In-Band ECC" = Enabled.
• In-Band ECC Operation
Mode
• IBECC Protect Region 0
Protect Region 0 BASE
•
Protect Region 0 MASK
•
IBECC Protect Region 1
•
• IBECC Protect Region 2
IBECC Protect Region 3
•
IBECC Protect Region 4
•
• IBECC Protect Region 5
• IBECC Protect Region 6
IBECC Protect Region 7
•
Firmware/BIOS description SIMATIC IPC227G, IPC277G
Operating Instructions, 05/2021, A5E50059883-AA
Value Setting in delivery
state
IPC227G
IPC277G
Enabled
Disabled x
0 x
1
Enabled
Disabled x
[0]
[16128]
Enabled
Disabled x
Enabled
Disabled x
Enabled
Disabled x
Enabled
Disabled x
Enabled
Disabled x
Enabled
Disabled x
Enabled
Disabled x
Meaning
In-Band ECC(Error Correction Code) is enabled.
In-Band ECC is disabled.
Functional mode protects requests based on the address
range.
Makes all request protected and ignore range checks.
In-Band ECC for Region 0 is enabled.
In-Band ECC for Region 0 is disabled.
The Base is the start of the region and its value is multi-
ples of 32MB in decimal.
The Mask is the size of the region and its value is (0x4000
- multiples of 32MB) in decimal.
In-Band ECC for Region 1 is enabled.
In-Band ECC for Region 1 is disabled.
In-Band ECC for Region 2 is enabled.
In-Band ECC for Region 2 is disabled.
In-Band ECC for Region 3 is enabled.
In-Band ECC for Region 3 is disabled.
In-Band ECC for Region 4 is enabled.
In-Band ECC for Region 4 is disabled.
In-Band ECC for Region 5 is enabled.
In-Band ECC for Region 5 is disabled.
In-Band ECC for Region 6 is enabled.
In-Band ECC for Region 6 is disabled.
In-Band ECC for Region 7 is enabled.
In-Band ECC for Region 7 is disabled.
Configure firmware
2.4 "Advanced" tab
15