Shooting Assist Item; Marker Settings Item - JVC JY-HM360E Instructions Manual

Shooting Assist Item

Focus Assist
For setting whether to add color to the contour of
the focused image upon switching the image to
black-and-white.
[Setting Values: On, ROff]
9 Ring
For setting the focus/zoom ring operation.
SW Set:
0
This follows the settings of the [FOCUS/
ZOOM] operation switch.
Focus:
0
When the Focus Assist function is activated,
focusing operation is possible regardless of the
settings of the [FOCUS/ZOOM] operation
switch.
[Setting Values: RSW Set, Focus]
9 Color
For setting the display color of the focused area
when Focus Assist is activated.
[Setting Values: RBlue, Green, Red]
Zebra
For selecting whether to display zebra patterns at
the bright areas of the subject.
Select "On" to display zebra patterns or "Off" to
hide.
[Setting Values: On, ROff]
9 Top
For setting the maximum luminance level for the
zebra pattern display.
[Setting Values: Over, 100%, 98%, 95% to 5% (in
5% increments)] (R80%)
9 Bottom
For setting the minimum luminance level for the
zebra pattern display.
[Setting Values: 100%, 98%, 95% to 0% (in 5%
increments)] (R70%)
Memo :
The relation between Top and Bottom is such
0
that Top>Bottom always holds. To maintain this
relation during setting, the setting value is
automatically corrected.
Focus Assist & Zebra
For selecting the operation when [Focus Assist]
and [Zebra] are used simultaneously.
Standard: The focus assist outlines will
0
overlapped the zebra pattern.
ALT: The focus assist outlines will not
0
overlapped the zebra pattern, however, flicker
may occur on the zebra area.
[Setting Values: Standard, RALT]

Marker Settings Item

For setting the marker and safety zone, which are
useful in helping you determine the angle of view
for the image according to the shooting purpose.
(A P119 [Marker and Safety Zone Displays
(Camera Mode Only)] )
Memo :
During Clip Review or when in the Media mode,
0
the markers do not appear regardless of the
setting.
Marker
For setting whether to display marker, safety zone,
and center marks on the screen.
[Setting Values: On, ROff]
9 Grid Marker
For setting whether to display a 3x3 grid on the
screen.
[Setting Values: On, ROff]
Memo :
When [Grid Marker] is set to "On", [Aspect
0
Ratio], [Aspect Marker], and [Safety Zone] do
not function.
9 Aspect Ratio
For selecting the final image aspect ratio to be used
from the overall angle of view.
[Setting Values: 16:9(+4:3), 2.35:1, 1.85:1, R16:9,
1.75:1, 1.66:1, 14:9, 13:9, 4:3, 2.35:1 Center,
2.35:1 Top, 1.85:1 Center, 1.85:1 Top]
Memo :
When [System] B [Record Set] B [Record
0
Format] B [SD Aspect] is set to "4:3", this item
is fixed at "4:3" and cannot be selected.
(A P105 [ SD Aspect ] )
97
LCD/VF Menu