Table of Contents
Advertisement
Symptom
The time code and user's bit
are not displayed.
The date and time are not
displayed.
Incorrect display on the
viewfinder.
The actual recording time is
shorter than the estimated
time.
The two camera recorders are
not synchronized even though
the time codes have been
synchronized. (Z on the Slave
device is not displayed.)
130
Troubleshooting
Even in Camera mode or Media mode, the time code and user's bit
0
may not be displayed depending to the type of display.
Is [LCD/VF] B [Display Settings] B [TC/UB] set to "Off"? To display
0
the time code or user's bit, set it to "TC" or "UB".
(A P98 [ TC/UB ] )
The date and time are only displayed on the Display 1 and Display 2
0
screens in the Camera mode (during shooting).
(A P112 [Display Screen in Camera Mode] )
Is [System] B [Record Set] B [Time Stamp] set to "On"? To display
0
the date and time, set it to "Off".
(A P107 [ Time Stamp ] )
Is the LCD monitor used with [LCD/VF] B [LCD + VF] set to "Off"?
0
(A P96 [ LCD + VF ] )
The recordable time may be shorter depending on the shooting
0
conditions or the subject.
Is the [TC IN/OUT] switch correctly set?
0
(A P64 [Synchronizing Time Code on Another Camera] )
Set [System] B [Record Set] B [Record Format] B [Frame & Bit
0
Rate] such that the two camera recorders have the same frame rate.
(A P105 [ Frame & Bit Rate ] )
Action
Advertisement
Table of Contents
