One-Piece Front Turn Signal Lamps - Chevrolet 2003 Blazer Owner's Manual

4. Turn the bulb/socket assembly counterclockwise to
remove it.
5. Put the new bulb/socket assembly into the
headlamp assembly and turn it clockwise until it is
tight.
6. Plug in the electrical connector.
7. Put the headlamp assembly back into the vehicle.
8. Install the two retaining clips.
9. Close the hood.
One-Piece Front Turn Signal Lamps
1. Remove the headlamp assembly as shown
under Headlamps on page 5-49 for "One-Piece
Composite Headlamp System."
2. Twist the bulb socket
to remove it from the
headlamp assembly.
3. Pull the bulb straight out to remove it from the
4. Push the new bulb into the socket until it snaps into
5. Put the bulb socket into the lamp assembly and
6. Put the headlamp assembly back into the vehicle.
7.
Install the two retaining clips.
8. Close the hood.
socket.
place.
turn it clockwise until it is tight.
5-5 1