Chevrolet 2003 Blazer Owner's Manual page 138

LO (Low Speed): Turn the band away from you to LO
and past the delay settings for steady wiping at low
speed.
HI (High Speed): Turn the band away from you, to
and past the delay settings for wiping steady at high
speed.
Delayed Wiping: You can set the wiper speed for a
long or short delay between wipes. Turn the band
to choose the delay time. The closer to LO, the shorter
the delay.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
worn or damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
Windshield Washer
There is a paddle marked with the windshield washer
symbol at the top of the multifunction lever. To
spray washer fluid on the windshield, push the paddle.
The wipers will clear the window and then either
stop or return to your preset speed.
In freezing weather, don't use your washer
until the windshield is warmed. Otherwise the
washer fluid can form ice on the windshield,
blocking your vision.
Rear Window WasherNViper (If Equipped)
This control is located on
the instrument panel to
the right of the steering
wheel.
To turn the rear wiper on, slide the control to either
LO or HI. For delayed wiping, slide the control to LO.
For steady wiping, slide the control to HI. To turn
the wiper off, slide the control to OFF.
3-9