One-Piece Front Turn Signal Lamps - Chevrolet S10 Pickup 2003 Owner's Manual

5. Turn the bulb assembly counterclockwise to remove
it from the headlamp assembly.
6. Put the new bulb into the bulb assembly and
reinstall it in the headlamp assembly by turning
it clockwise until it is tight.
7. Plug in the electrical connector.
8. Put the headlamp lens assembly back into the
vehicle.
9. Install the two retaining clips.
10. Close the hood.
5-56

One-Piece Front Turn Signal Lamps

1. Remove the headlamp assembly as shown in
"One-Piece Composite Headlamp System"
under Headlamps on page 5-54 .
3. Pull the bulb straight out to remove it from the
socket.
4. Push the new bulb into the socket until it snaps into
place.
5. Put the bulb socket into the lamp assembly and
twist it clockwise until it is tight.
6. Put the headlamp assembly back into the vehicle.
7. Install the two retaining clips.
8. Close the hood.
2. Twist the bulb socket
counterclockwise to
remove it from the
headlamp assembly.