Chevrolet 2002 Venture Owner's Manual page 150

Canadian Owners: If you lose or damage your keys,
only a GM dealer can service PASS
keys made. To program additional keys you will need
two current driver's keys (black in color). You must add
a step to the following procedure. After Step 3 repeat
Steps 1 through 3 with the second current driver's key.
Then continue with Step 4.
To program the new key:
1. Verify the new key has PK3 stamped on it.
2. Insert the ignition key in the ignition and start the
engine. If the engine will not start see your dealer
for service.
3. After the engine has started, turn the key to OFF and
remove the key.
4. Insert the key to be programmed and turn it to RUN
within 10 seconds of removing the previous key.
2-42
-
Key III to have new
5. The security message will turn off once the key has
been programmed. It may not be apparent that the
security message went on due to how quickly the key
is programmed.
6. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the security message comes
on and stays on, you will be able to restart your engine if
you turn it off. Your PASS
not working properly and must be serviced by your
dealer. Your vehicle is not protected by the
-
PASS Key III system at this time.
If you lose or damage a PASS
dealer or a locksmith who can service PASS
have a new key made. In an emergency, call Chevrolet
Roadside Assistance. See "Roadside Assistance" in the
Index for more information.
-
Key III system, however, is
-
Key III key, see your
-
Key III to