Everlast EV720 Owner's Manual page 31

GENERAL MAINTENANCE
WARNING!
ALWAYS UNPLUG YOUR TREADMILL PRIOR TO CLEANING TO AVOID ELECTRICAL
HAZARD OR SHOCK.
Belt and Deck - Your treadmill uses a very high-efficient low-friction deck. Performance is
maximized when the deck is kept as clean as possible. Use a soft, damp cloth or paper towel to
wipe the edge of the belt and the area between the belt edge and frame. Also, reach as far as
practical directly under the belt edge. This should be done once a month to extend belt and deck
life. Use water only - no cleaners or abrasives. A mild soap and water solution along with a nylon
scrub brush will clean the top of the textured belt. Allow to dry before using.
Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess off with a
damp cloth will minimize buildup.
General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the running belt.
On a monthly basis, vacuum underneath your treadmill to prevent buildup.
Once monthly, you should remove the black motor hood and vacuum out dirt that may accumulate.
UNPLUG POWER CORD BEFORE THIS TASK.
Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a light
application of car wax. Do not use aerosol sprays or pump bottles as they may deposit wax upon
the walking or computer surface. Under no circumstances are you to use ammonia, oils, silicones,
or any other compounds on the rubberized walking surface. The use of such materials may cause
serious injury to the body and/or deteriorate the performance of the walking surface. Only clean the
rubberized walking surface with a damp cloth (water only). From time to time, the computer surface
may collect dust or fingerprints. The use of harsh chemicals will destroy the protective coating and
cause a static build-up that will damage the components. This surface may be cleaned with
specially prepared chemicals found in most computer supply stores especially made for anti-static
surfaces. It is strongly recommended that you purchase such a cleaning compound.
TREADMILL LUBRICATION
Your treadmill should require little maintenance other than periodically applying lubricant.
Lubricating under the tread belt will ensure superior performance and extend its life expectancy.
HOW TO CHECK IF THE TREADBOARD REQUIRES LUBRICATION
Lift one side of the tread-belt and feel the top surface of the tread board. If the surface is (slick) to
the touch, then no further lubrication is required. If the surface is dry to the touch, apply one packet
of lubricant or half of the bottle of lubricant.
LUBE MESSAGE
When "LUBE" appears on the LCD check lubrication under walking belt. (Use a total of 90 hours.)
After application, hold PROGRAM for 3 seconds to reset the message.
Customer Service 1-888-707- 30
1880 Dyaco Canada Inc. 2021
Email: customerservice@dyaco.ca