Westfalia Joker Maintenance And Operation page 11

Bringing into operation (LPG)
The fridge is designed for use with Propane or Butane gas only.
Natural gas or city gas must not be used.
1. Open the valves (main valve of the gas tank, and quick release
valve in the kitchen cupboard)
2. Turn the thermostat knob (B) clockwise to the max setting.
3. Press in button (E). Straight after pressing the button, the
electronic gas ignition will switch on, the red signal light (F) will
light up.
4. Press button (A) in and keep it pressed in. After 20-30 seconds,
the burner will automatically ignite. As soon as the flame lights,
the ignition will stop, and the red signal light (F) will go out. Keep
the button (A) pressed in for another 15-20 seconds, then the
thermo-electric ignition from the LPG tank will stay open.
Translated into English by www.westfaliat3.info – a useful website for VW Westfalia T25 / T3 / Vanagon Camper enthusiasts.
You can see the progress of the ignition steps by flashing light (F).
The use of the burner flame is shown by control light (G) (see
below) as long as switch (A) on the cooker display is switched on.
Should there be a cause (other than the LPG tank being empty) for
the gas flame to go out, it will ignite again automatically. If it does
not ignite due to a defect, the protection mechanisms will activate
and will automatically shut off the LPG supply.
5. When not in use or if the fridge has a problem using gas, stop
the gas supply to the fridge & switch off button (E) by using
button (C) or (D).
Regulating the temperature of the fridge
You can regulate the temperature of the fridge by using the
combined electric / gas thermostat. After sufficient cooling in the
max position, you can turn the temperature knob (B) anticlockwise
to your desired temperature.
Important Notice !
Always watch out that the fridge is never connected to 2 power
sources (i.e.: gas & electricity) at the same time. It would then not
work, and will possibly suffer damage. Such damage would not be
covered by the warranty.