Battery Status Indicator - Projecta INTELLI-START Quick Start Manual

Note: In general, with the use of Rapid Recharge Technology (RRT) the Jumpstarter does
not require charging. However, while not in use it is recommended to check the
Jumpstarter's charge status via the BATTERY STATUS INDICATOR. If required, charge
the Jumpstarter using the supplied 12V USB charger or a 3rd party 10W 240VAC USB
adaptor (not provided). This will ensure the Jumpstarter is ready when required.
UNDERSTANDING YOUR JUMPSTARTER
CLAMP CONNECTION LED
Jumpstart Status
Jumpstarter clamps connected to vehicle and ready to jumpstart
Jumpstarting for more than 5 seconds
Battery or Jumpstarter switch, over-temperature
Battery charging temperatures >45°C or <0°C
Short circuit
Clamps reverse connected to battery
Jumpstarter input voltage (EC5 connector) > 15.0V
Low voltage indication
Hardware failure

BATTERY STATUS INDICATOR

When Jumpstarter is turned on the battery gauge LED's are displayed as follows:
State of Charge Battery Gauge LED Display
<20%
20–25%
25–50%
50–75%
75–100%
When Jumpstarter is charging the battery gauge LED's are displayed as follows:
State of Charge Battery Gauge LED Display
<20%
20–50%
50–75%
75–99%
100%
8
– Red flashing
– Red
– Yellow
– Green
– Green
– Scrolling
– Red with Yellow & Green scrolling
– Yellow with Green scrolling
– Green with Green flashing
– All solid Green
LED
Green solid
Yellow flash twice, pause & repeat
Red / Green alternate flashing
Red / Green alternate flashing & siren
Red flashing & beeping siren
Red solid & siren on
Red / Yellow alternate flashing & siren on
Red flashing, no beeping siren
Red fast flash, steady siren on