Output Settings - Panasonic KAIROS Operating Manual

Picture 3.3.9.2.25
Picture 3.3.9.2.26

3.3.9.3 Output Settings

Picture 3.3.9.3.1
The " " symbol indicates that at least 1 audio group (ST2110-30) is enabled for this output. When
"Delay" is activated, the indicator
Similar to the "Input Settings," the "Output Settings" GUI menu shows a list of all 16
outputs, each capable of a 3G signal bandwidth. The output types are selectable
between ST2110, SDI, NDI, and Stream (Picture 3.3.9.3.2).
Note: 16 Outputs are accessible only when license AT-SF002 (I/O expansion) is
installed. By default, there are 12 Outputs available.
Picture 3.3.9.3.2
Out of a group of 4, only the first output can select 4K (indicated with the yellow
case, all other outputs in that group will be disabled (see the list of available formats in Picture 3.3.9.3.3).
"VtrController-Tab":
In the "VtrController" Tab, enter the individual IP
address and Port number for a supported device
and then select "Protocol" type for the device. A
dedicated driver for BlackMagic devices, as well
as AMP over LAN protocol (Advanced Media
Protocol), is available (Picture 3.3.9.2.26). If the
connected device supports a multi-channel
infrastructure, it might be necessary to specify
the channel number to "talk" to. When the
settings are completed, hit the "Connect" button
to establish communication. The "Available" and
"Connected" check-boxes should indicate
appears next to the designated "More" button.
.
Group 1-4
Group 5-8
Group 9-12
Group 13-16
symbol). In this
91