Chevrolet 2000 Tahoe Owner's Manual page 200

If your vehicle is equipped with the AM
Cassette Tape Player:
1. Turn the ignition to RUN or ACCESSORY.
2. Turn the radio on.
3. Insert the scrubbing action cleaning cassette.
4. Within five seconds, press and hold the REV and
FWD buttons at the same time for three seconds.
The tape symbol on the display will flash, showing
that the cut tape detection feature is no longer active.
5. Eject the cleaning cassette after the manufacturer's
recommended cleaning time.
If your vehicle is equipped with the AM
Cassette Tape Player and Automatic Tone Control:
1. Turn the ignition to RUN or ACCESSORY.
2. Turn the radio off.
3. Press and hold the TAPE AUX button for five
seconds. The tape symbol on the display will flash
for two seconds.
3-36
-
FM Stereo with 4. Insert the scrubbing action cleaning cassette.
5. Eject the cleaning cassette after the manufacturer's
recommended cleaning time.
When the cleaning cassette has been ejected, the cut tape
detection feature is active again.
You may also choose a non
cleaner which uses a cassette with a fabric belt to clean
the tape head. This type of cleaning cassette will not
eject on its own. A non
not clean as thoroughly as the scrubbing type cleaner.
The use of a non
cassette is not recommended.
-
FM Stereo with
After you clean the player, press and hold EJECT for
five seconds to reset the CLN indicator. The radio will
display
Cassettes are subject to wear and the sound quality
may degrade over time. Always make sure the cassette
tape is in good condition before you have your tape
player serviced.
-
scrubbing action, wet
-
scrubbing action cleaner may
-
scrubbing action, dry
---
to show the indicator was reset.
-
type
-
type cleaning