Chevrolet 2000 Tahoe Owner's Manual page 141

3. Return to the HomeLink Transmitter in your vehicle
and firmly press and release the HomeLink
Transmitter button you have already programmed for
two to three seconds. Press and release the button
again (you may need to do this step up to three times)
to make sure that the HomeLink Transmitter has been
trained to the garage door opener motor head unit.
Check that the training was successful. The motor
head unit indicator light should no longer be flashing.
The garage door opener should now recognize the
HomeLink Transmitter. You may either use the
HomeLink Transmitter or the hand
to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, call the
manufacturer of the unit at 1
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (after 20 seconds). Release both buttons.
Accessories
Accessories for the HomeLink
available from the manufacturer of the unit. If you
would like additional information, please call
- - -
1 800 355 3515.
-
held transmitter
- - -
800 355 3515.
R
Transmitter are
R
OnStar System (If Equipped)
OnStar is a vehicle communications service. The
following services are available through a subscription
with OnStar and are available 24 hours a day:
Emergency Services
D
Automatic Notification of Air Bag Deployment
D
-
Stolen Vehicle Tracking
D
Roadside Assistance with Location
D
Remote Diagnostics
D
-
OnStar MED NET
D
Accident Assist
Convenience Services
D
Remote Door Unlock
D
Route Support
D
Concierge Services
D
Ride Assist
A complete user's guide is provided with the OnStar
System. For more information, contact OnStar
- -
1 888 ONSTAR7.
2-65