Table of Contents
Advertisement
In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1.
2.
3.
4.
Tune in the desired station.
Press
SET.
(SET
will appear on the display.)
Press any
two
adjoining pushbuttons at the same time,
within
five
seconds. The sound will mute. When it
returns, release the buttons. Whenever you press the
same buttons, the station you set will return.
Repeat the steps for each pair of pushbuttons.
P.SCAN:
Press both SEEK arrows and P.SCAN will
appear on the display. Use
PSCAN
to listen to each of
your preset stations for a few seconds. The radio will go to
the frst preset station stored on your pushbuttons, stop for
a few seconds, then go on to the next preset station.
(If
a
preset station has weak reception, it will not stop.) Press
either SEEK arrow or the upper knob to stop scanning.
Setting the Tone
,
BASS: Slide the lever up or down to increase or
decrease bass.
TREB: Slide the lever up or down to increase or
decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
Adjusting the Speakers
BAL: Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE: Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are
so
thin they may not work well in this player.
If you hear nothing or hear just a garbled sound, it may
not be in squarely. Press EJECT to remove the tape and
start over.
While the tape is playing, use the VOL, FADE, BAL,
BASS and TREB controls just as you do for the radio.
Other controls may have different functions when a tape
is inserted. The display will show an arrow to show
which side of the tape is playing.
REV:
Press the SEEK arrow pointing to the left and
the
tape will reverse rapidly until you press this button
again lightly.
Advertisement
Table of Contents
