Download Print this page
D-D The Aquarium Solution Aqua-Pro Reef Series Installation Instructions Manual

D-D The Aquarium Solution Aqua-Pro Reef Series Installation Instructions Manual

Advertisement

Quick Links

AQUA-PRO AQUARIUMS
Installation Instructions
For the Aqua-Pro Reef aquarium range
FOLLOW US FOR INSPIRATION!
.com/theaquariumsolution
.com/groups/ddaquapro
www.theaquariumsolution.com

Advertisement

loading

Summary of Contents for D-D The Aquarium Solution Aqua-Pro Reef Series

  • Page 1 AQUA-PRO AQUARIUMS Installation Instructions For the Aqua-Pro Reef aquarium range FOLLOW US FOR INSPIRATION! .com/theaquariumsolution .com/groups/ddaquapro www.theaquariumsolution.com...
  • Page 2: Step 2 Levelling The Cabinet

    D-D Aqua-Pro Reef Systemised Aquarium Please read the following installation instructions carefully before starting to assemble and run your aquarium. If correctly installed, your new aquarium should give you years of pleasure in this fantastic and enthralling hobby. STEP 1. POSITIONING THE AQUARIUM Checking the aquarium on arrival Transport damage –...
  • Page 3 Wooden Cabinet removable weir comb section and set aside in a safe place. The wooden cabinet should ideally be positioned on a level, flat floor. If the floor is not completely level or The three pipes can be installed in any order, but the flat, then it will be necessary to use suitable shims to following will allow for the easiest install.
  • Page 4 section in the weir box clockwise to screw the pipes AQUA-PRO REEF 600 SUMP LAYOUT together until they are hand tight. Top up Skimmer / Return pipe reservoir Equipment Take the long 25mm diameter pipe, remove the blue tape from the threaded end and ensure the rubber seal Return Refugium / is in place.
  • Page 5 the main overflow pipe is fully open, the handle should The easiest way to find out how far you need to reduce be in line with the direction of the pipe, and that the the height of these is to firstly, with the return pump flare outlet nozzles just under the surface of the water still switched off, remove enough water from the sump and angled down slightly.
  • Page 6 Adjusting the cabinet doors with an even gap, and close without any obstruction. The push-openers can also be adjusted by twisting them The doors are pre-set in the factory before packing in or out, by hand. but the hinges may need to be adjusted slightly once The hinges can show signs of rust over time if splashed the aquarium is in its final location.

This manual is also suitable for:

Aqua-pro reef 600Aqua-pro reef 900Aqua-pro reef 1200Aqua-pro reef 1500Aqua-pro reef 1800