Step 4 - Connect And Secure The Drain Hose - Haier HE HLPW028BXW Installation And User Manual

Install bottom cover.
Lock all four casters prior to operating washer.
Failure to do so can result in death, electric shock or personal injury.
5. Lock each caster by pressing down on the caster lever.
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
6. Using two or more people stand the washer upright.

STEP 4 - CONNECT AND SECURE THE DRAIN HOSE

1. Enlarge the opening by squeezing the ends of the drain hose clamp together.
Slide the clamp over the end of the drain hose, and onto the flexible section of
the hose.
2. Fit the drain hose rubber end over the plastic drain port on the washer.
3. Squeeze the ends of the clamp to enlarge the opening, and then slide the drain
hose clamp over the connection of the drain hose rubber end and drain port.
Release the clamp to tighten.
4. Place the drain hose (hook end) in a wall drain pipe, standpipe or laundry tub.
NOTE:
The drain hose will shake when water is being pumped out of the
washer.
5. Secure the drain hose in place by fastening it to a water hose, the standpipe, or
a leg on the laundry tub. See "Drain System Requirements" for illustrations.
6. Check all hose connections to ensure the connections are tight.
WARNING
Electrical Shock Hazard
WARNING
Excessive Weight Hazard
16