Advertisement
7.
Put the gimbal like this picture, and absolutely insuring the gimbal is still
at the horizontal. And then click "Init Gyro". At this moment, data will
appear on the three data frames of the gyro. And click "Init Gyro"
continuously until the red color turns green color. And click "Save All". It
will appear "Initialize Gyro success". And the initialize gyro is finished.
(Attention! Does the "Save All" step)
2
Hohem Techonology Co.,Ltd http://www.hohem-tech.com
8.
Calibration of the six surfaces of the accelerometer. According to
the steps calibrate the six surfaces step by step.
Firstly, click "Reset Para".
And then, put the gimbal like following every picture. And click
"Calibr Acc" until the red color turns green color . That means the
accelerometer data is within the diagrammatic data.
Tel:0755-86573216 Email:service@hohem-tech.com
Advertisement
