12 Volt Dc Demand Pump; Water Pressure Regulator; Lp Gas Connections And Start Up - Jayco Granite Ridge Greyhawk Escapade 2005 Owner's Manual

12 VOLT DC DEMAND PUMP

To utilize water from your water tank, you need to have 12 volt DC power to operate the
demand pump. Energy for the pump is supplied by the auxiliary battery or converter.
Depending on your motorhome model, the demand pump will be located under the bed, in a
cupboard, under the unit or under the sink. The switch to operate the pump is located on the
monitor panel or a wall near the pump.
Refer to instructions supplied by the pump manufacturer with your . If you have questions,
consult with your independent, authorized dealer and/or visit the manufacturer's website at
www.shurflo.com.
.
NOTE: The water pump switch should be in the off position when the camper is left
unattended for any amount of time. If something would happen to the water system,
this will help limit water damage to a smaller area.

WATER PRESSURE REGULATOR

Excessive pressure from water supply systems may be encountered in some parks,
especially in mountain regions. Water pressure regulators are available to protect your
system against such high pressure. A regulator of this type is recommended to prevent
damage to the plumbing system or components.
Caution: Not using a water pressure regulator when using city water may cause the
o-rings to blow. It is advisable to always use a water pressure regulator when using
the city water connection.

LP Gas Connections and Start Up

I
WARNING: LP gas can be extremely dangerous. Make sure that you
read, understand and follow all information supplied in this manual
and all component part manufacturers before operating your LP gas
system.
After the camper is completely set up and you are prepared for camping enjoyment, follow
these steps for LP gas operation.
1. Close all the burner valves, controls and pilot light valves.
2. Open the main valve on the LP gas tank slowly to avoid a fast rush through the
excess flow valve causing a "gas freeze." If you experience a gas "freeze-up,"
close the main valve and wait fifteen (15) minutes before trying again.
3. Listen carefully as the gas begins to flow. If "hissing" is heard for more than one
or two seconds, this may indicate a leak. Immediately close the valve and search
for the leak.
4. Light the appliances as needed and directed in the appliance manufacturer's
instructions.
Make sure that you read, understand and follow ALL safety requirements for handling and
operation of the LP gas system. Literature is supplied with your unit from the manufacturer
of the various appliances hooked to your LP gas system. The LP gas system provides added
benefits to your camping enjoyment, however, it must be handled with care. If you have
Granite Ridge/Greyhawk/Escapade Type C Motorhome
Setting Up Camp...
49