Table of Contents
Advertisement
8, Press BAND and
000
will appear again. Now you are ready to enter the
9. Repeat steps 6 and
7
for the last three digits of your code.
last three digits of your code.
10. Press BAND and rEP will appear for 5 seconds and then 000 will
11. Repeat steps 6 through 10. This time SEC will appear-indicating that
appear.
the radio is secure.
To Unlock The System After A Fower
Loss
When battery power is reapplied to a secured radio, the radio won't turn on
and LOC will appear on the display.
Enter your secret code as follows: pause no more than
15 seconds between
steps.
1. Turn the ignition on. (Radio off
.)
2. Depress the SET button. The display will show 009.
3. Enter the six digits of the code following steps 6-9 above. The display
4.
Depress the BAND knob and the time appears
-
indicating that the
disabling sequence was successful. If the display indicates SEC, the
numbers did not match and the unit is still secured.
will show the numbers as entered.
Disabling The Theft System
1. Depress presets 1 and
4 f?r
5 seconds with ignition on and radio power
off. The display will show SEC, indicating the unit is in the secure
mode.
2. Depress the SET button. The display will show 000.
3. Enter the first three digits of the code following steps 6 and 7 of the
4. Depress the
BAND knob. The radio will display 000.
preceding paragraphs. The display will show the numbers as entered.
5. Enter the second three digits of the code. The display will
L-- JW
the
6. Depress the BAND knob. If the display shows
"-
- -
", the disabling
numbers as entered.
sequence was successful. The numbers matched the user-selected code
or the factory back-up code, and the unit is in the UNSECURED mode.
If the display shows SEC, the disabling sequence was unsuccessful and
the numbers did not match either of the codes and the unit will remain
in the SECURED mode.
3-21
Advertisement
Table of Contents
