Table of Contents
Advertisement
SCAN
When you press SCAN, the radio will go to the next station and pause and
will keep scanning until you press SCAN again. SCAN appears in the
graphic display.
Pushbuttons
The four pushbuttons let you return to favorite stations.
You can set the
pushbuttons for up to eight favorite stations (4
AM
and 4
FM).
Just:
Tune in the desired station.
Push the SET pushbutton (SET appears in the VF display for
Within the 5 seconds, push one of the four pushbuttons. Whenever you
5 seconds.)
press that button, the preset station will return.
NOTE:
In addition to the four stations set as above, up to two additional stations
may be preset on each band by pressing two adjoining pushbuttons at the
same time. Just:
Tune in the desired station.
Press the SET pushbutton (SET appears in the VF display for
5
seconds.)
Within 5 seconds, press any two adjoining pushbuttons at the same
time. (The station will return when the same two buttons are pressed
again.
Clock
To set the clock, just:
Press the SET pushbutton.
0
Within 5 seconds, press and hold S
:K
until the correct minute
Press and hold SCAN until the correct hour appears on the display.
appears on the display.
Adjust the Tone
Use the levers in the upper left corner to set the bass, midrange, and treble
until you get the sound you want. The 60 and 250 levers adjust the bass;
1K is midrange; and 3 S K and 1OK control the treble.
We suggest you start with
the
center lever (1K) in the midpoint position,
then move the others up until you get the amount
of bass and treble you like.
Am-St Button
The Am-St is just below the SEARCH button. Push this when you tune to
an AM station that broadcasts in stereo. Your STEREO light will come on
when you're receiving AM stereo. If you push A m S t and there is no more
noise, it means the station is weak. You'll hear the station better if you don't
use Am-St. Just push theAm-St button again to delete stereo.
3- 14
Advertisement
Table of Contents
