Silvercrest SWCD 1000 A1 Manual page 33

Attachment fi tting / removal
WARNING! RISK OF INJURY!
► After operation, the appliance components may be hot!
Fitting Attachments
Insert the desired attachment into the attachment insertion slot 1, so that
■
the front arrow symbol on the attachment points at the arrow symbol on the
attachment insertion slot 1
■ Turn the attachment clockwise until it clicks into place. The back arrow on
the attachment now points at the arrow on the attachment insertion slot 1
Removing attachments
■ First switch the appliance off and allow it to cool down..
Press the release button "push" 7 and turn the attachment anti-clockwise
■
■ The attachment can now be removed by pulling it out of the attachment inser-
tion slot 1.
Switching on/off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
–
–
–
You switch the appliance off by sliding the level switch 3 to the position "0"
■
(= appliance off ).
To fi x the styling, you can use the slide switch Cool Shot 2. The styling will
■
be fi xed by the cool air stream:
–
–
SWCD 1000 A1
.
.
"0" The appliance is switched off
"1" for a reduced air-fl ow strength with heat
"2" for a high air-fl ow strength with heat
During operation, slide the slide switch Cool Shot 2 upwards.
The air fl ow will be cooler.
When you want to deactivate the cool air stream, slide the slide switch
Cool Shot 2 downwards.
.
GB
31