Modify Height; Resurrection System - Wasp Delta 4070 Pro Manual Of Use And Maintenance

8
Use of the printer

8.6. Modify height

The height of the printer is the distance (in mm) set between the tip of the nozzle and the printing plane.
It is a fundamental requirement for calibration.
It is necessary in the case of:
• Change of extruder
• Cartridge change
• Replacement of print bed
NOTE:
If the height set is lower than this measure, the tool will work higher than necessary (preventing the material from
attaching properly to the floor).
If the set height is higher than required, the tool will work at a level below the printing plane (with consequent
damage to the plane and tool).

8.7. Resurrection system

The Resurrection system is a command for the automatic recovery of the print jobs interrupted by a sudden
switch-off during processing.
The system is designed in particular for:
• Blackouts and sudden power failures during printing
• Accidental removal of the power cord during printing
In addition, it should be considered that in the time span between turning off the machine and launching the
"Resurrection" command, the printed piece is cooled which in some cases may cause problems in recovering
the print.
52
© CSP S.r.l.