Operators For Whom The Manual Is Intended; Protection Systems; Residual Risks - Wasp Delta 4070 Pro Manual Of Use And Maintenance

1.5.2. Operators for whom the manual is intended

The manual is written for:
• The operators involved in using the printer (in the continuation of the manual will be briefly called "users");
• Mechanical maintenance workers: trained and authorized operators for the maintenance of mechanical
parts, pneumatic and oil-hydraulic systems;
• Electrician maintenance technicians: trained and authorized operators for the maintenance of electrical and
/ or electronic parts and systems;
• Qualified technicians (employees of the Manufacturer or authorized service center), special maintenance
staff and operations of a complex and / or particular nature.
ATTENTION:
The user must not perform operations reserved for maintenance personnel or qualified technicians.
The manufacturer is not liable for damages deriving from failure to observe this prohibition. Users
or qualified technicians.

1.5.3. Protection systems

The machine is provided with automatical systems of protection that reduces the risks for the user.
These systems are present as a standard in all machines and shall not, for any reason, be manipulated nor
damaged. Seeing abnormalities in the fuctions of these systems the user is responsible of reporting them to the
Manifacturer, who'll fix it.
Anytime the fuctions of these systems are compromised the machine must not be used for no reason as it may
be dangerous for the user and may lead to major damages to the machine itself.
DOOR SENSOR
ATTENTION:
Do not put any magnet or magnetic device near the frame of the door as it may compromise its right
behaviour
The Door sensor activates anytime the door is open and automatically pauses any action on the machine
(including heating, movements and tool-change).
OVERHEATING BLOCK
The machine is designed with a control system to prevent the overheating of its parts by blocking the heating
parts as the temperatures recorded overcome the saftey threshold.

1.5.4. Residual risks

Residual risk of scalding
This risk exists during the removal phase of the filament from the extruder and during the removal of the piece
from the plate.
© CSP S.r.l.
1 1
11