Gear Housing - Spindle Shaft - Husqvarna DM220 Workshop Manual

GEAR HOUSING – SPINDLE SHAFT
Remove the wedge.
A small pair of lock ring pliers is needed
to remove the lock ring, manufacture:
Milbar/Imperial IR-15R or equivalent
Start by turning the lock ring to ensure
the opening is accessible by pliers in the
gear wheel.
Milbar/Imperial
IR-15R
Expand the lock ring using the pliers and
lift the ring up slightly. Lift the opposite
side of the ring with a hook. Lift the lock
ring off the shaft.
Lift off the gear wheel.
The gear housing after removal of the
intermediate shaft and the spindle shaft
components.
6
13