Dismantling In Basic Modules - Husqvarna DM220 Workshop Manual

Hide thumbs Also See for DM220:
Table of Contents

Advertisement

1
3
1
DISMANTLING BASIC MODULES
2
4
2
Gear housing/electric motor
Virtually all service work requires the separation of the
gear housing from the electric motor. The process of
dismantling the machine in to its basic components is
described in this chapter.
Separation
Gear housing/motor housing
The handle halves must be removed so that the screws
that hold the electric motor to the gear housing can be
accessed.
1. Remove the two screws holding the inspection cover
for the carbon brushes. Remove the cover.
2. Remove the three screws connecting the handle
halves and the two screws that hold the handle half to
the motor.
3. Lift off the handle half.
4. Turn the machine and remove the two screws that
hold the other handle half.
Pull the connector for the power cables out of its
compartment. An earth wire runs from the gear hou-
sing, under the stator, to the connector.
1. Locate the yellow/green earth wire that runs under
the stator.
2. Remove the earth wire from the connector.
4
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents