Attach The Mount To The Windshield And Start Recording - Kenwood DRV-A301W Instruction Manual

How to use the Adhesive Mount:
i. Loosen the (c) locking ring on the suction mount and pull the (e) magnetic
connector out.
ii. Next, loosen the (c) locking ring from the adhesive mount, and plug the
(e) magnetic connector into the adhesive mount.
iii. Clean the installation area on the windshield and peel off the plastic covering.
Adhere it to the windshield.
2.
ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING
Remove the protective plastic film and select a position on the windshield where it
won't distract you. Then, put the suction mount in place.
Release the (b) locking lever from the mount by pulling down on it. Hold the suction
mount in place and press against the window. While holding it in place, pull the (b)
locking lever back to lock the mount
Loosen
15
Tigten