Advertisement
Rubber bushings are used at the lower control arm pivots. The upper end
of the strut is isolated by a rubber mount which contains a bearing to
allow for wheel turning. The Speed Sensing Suspension automatically
controls the damping rate of the struts.
The lower end
of
the steering knuckle pivots on a ball joint riveted to the
control arm. The ball joint is connected
,to
the steering knuckle with a
castellated nut and cotter pin.
ShortlLong Arm Suspension (SLA)
Your vehicle uses an independent short/long arm rear suspension.
All
the
rear suspension components are mounted on a suspension support which
is attached to the body at four points and is fully isolated with bushings
and insulators to minimize road noise. Each rear wheel is connected to
the suspension support through the suspension knuckle using an upper
and lower control arm and toe link.
- -
Advertisement
