Advertisement
Fan Speeds
Push the (symbol)
button until "AUTO" is
displayed on the
screen.
At this setting, the fan speed is controlled automatically.
If it is cold outside, the blower may not run in the maximum high fan
speed right away. The system checks the temperature of the coolant to
assure it is warm enough to provide heat. When the coolant is warm, the
controllers will allow the fan to ramp up to a higher speed. This prevents
cold air from blowing into the passenger compartment.
If you want the blower fan to run only at a fixed high speed, push the
(upper) button until you see "HI" on the display.
If you want the fan speed to be automatic, but you like the fan speed to
be higher than the.AUT0 setting, just push the buttons until "HI/AUTO"
is shown on the display.
If you want the blower to run only at a fixed low speed, push the (low)
button until "LO" is shown on the display.
If you want the fan speed to run lower than the "AUTO" setting, push the
button until "AUTO LO" is shown on the display.
DEFROSTER
--
Push this button to
remove fog or frost
from the windshield.
This setting sends most of the air flow to the windshield with only a small
amount to the floor outlets.
The fan speed will work automatically to maintain your requested interior
temperature. If you need more air to your windshield, you should select a
higher fan speed.
In some cold start conditions, the AUTO fan speed may be limited until
the system warms up. This is normal
to
prevent windshield fogging.
It will help a lot if you first clear any ice and snow from the hood and the
air inlet (it's between the hood and the windshield).
Advertisement
