Casio DT-X100 Service Manual page 40

(6) Next, peel off the remaining release paper on the power key side of the DP-TAPE, and attach that peeled
section of the DP-TAPE to the U-CASE. In this case, be sure that the positions of the power key hole and
LED holes in the DP-TAPE coincide with those of power key and the LEDs.
(7) Strongly trace the adhesive section of the DP-TAPE's PET release paper to securely attach it to the
U-CASE.
(8) Remove the LED-LENS by peeling it off from
the removed DP-PANEL2. Then, by using
scotch tape or the like, completely remove
the old double faced tape from both the LED-
LENS and DP-PANEL2 so that no residue
remains.
(9) Attach the LED-LENS to the new DP-
PANEL2 with the new LED-TAPE.
(10) Peel off the DP-TAPE's PET release paper
attached to the U-CASE. In this case, push
the U-CASE from the back to make a gap,
and peel off the PET release paper by
inserting your nail into the gap.
(11) Peel off the protective sheet on the back
side of the new DP-PANEL2, and then
attach the DP-PANEL2 to the U-CASE
while aligning it with the concave part of the
U-CASE.
(12) Firmly attach the DP-PANEL2 to the
U-CASE by pinching them with your fi ngers
with a strong force.
DP PANEL2
LED-LENS
LED-TAPE
— 37 —