Programming The Ecm With New Software; Figure 4.12 Ecm Service Tool - Software Update - Carrier UG 15 Tier 4 Operation And Service Manual

Engine emission system, generator sets

Table of Contents

4.7

Programming the ECM with New Software

If the ECM needs to be updated with new firmware, use the ECM Service tool to do it. Refer to

1. From the Setup screen, click on the Firmware tab.

2. Click on the "Update ECM with firmware" button. A window will prompt to locate the new software file.

3. Choose the new software file and click Open. A window will open showing progress of the download.

4. Once the update is complete the message "Update successful" is displayed. Click OK.

5. Confirm that the software / firmware revision has been updated.

4–9

Figure

4.12.

T-378

Table of Contents