Mains Supply; Indications Following Power Up - Honeywell GENT COMPACT-MAINS-DAU Commissioning Instructions

Commissioning instructions

Mains supply

"
The fire alarm system products are NOT designed to be powered from IT Power systems.
All mains powered equipment of the fire alarm system must be earthed.
The mains supply to any Mains Powered DAU must be via an unswitched 5A fused spur unit. A disconnect device must be provided
to disconnect both poles and must have a minimum gap of 3mm. The Disconnect device should be available as part of the building
installation and must be easily accessible after installation is complete.
The fused spur isolator cover should be marked:
&
Hazardous voltage remains after operation of a protection fuse. Take appropriate action to guard
against the risk of equipment having exposed live mains supply.
&
Ensure that the mains supply cable enters the enclosure through a dedicated cable entry, located
adjacent to the mains terminal block and that is also segregated from loop wiring.

Indications following Power up

The indications shown below are those given once the Mains Powered DAU has fully powered up and the unit is in a quiescent
condition and is fault free:
12
www.acornfiresecurity.com
Dedicated mains supply
from consumer unit
5A Unswitched
Fused spur unit
Mains Powered DAU
FS3
3.15A(T)
mains fuse
N
L
PE
FIRE ALARM - DO NOT SWITCH OFF
On steady
Power
green
with door closed with door open
Fault Cancel
Buzzer
System Fault System Fault Speaker Circuit 1 VA Activated
Power Fault Speaker Circuit 2
Volume
Comms Fault Amplifier 1
Earth Fault Amplifier 2
Microphone Fault
Message Fault Power
Warning
by Honeywell
Removal of
cover exposes
DANGER live parts Voice Amplifier Unit
Mains Powered DAU - power up indicators
www.acornfiresecurity.com
Disconnect Device
(with minimum contacts
gap of 3mm)
Ensure the mains supply remains
isolated until system commissioning
stage when the unit is powered up.
Quick flash On steady Fast flash
blink every second
red
green
green
N PE L
L1 01 L2 02 I/A I/B O/A O/B I/A I/B O/A O/B IN+ IN- E 0V A 0V T 0V NO COM N/O COM N/C 0UT 0V OUT 0V S1+ S1- S2+ S2-
P2
FS3 3.15A(T)
VIGILON LOOP AUDIO LOOP PA LOOP LOCAL EVAC ALERT TEST AUX FAULT LINE LINE SPEAKER 1 SPEAKER 2
PB1 PB3 PB5 AUDIO PB12 PB13 PB14 PB15 RELAY PB2 RELAY OUT1 PB6 PB7 OUT2 PB10 PB11 Mains fuse
PB4 N L
VIG CONFIG
DISABLE
P12 ENABLE
1A0 (F)
FS1
1A0 (F)
FS2
P1
AMP 1
P22 P2
P1
P3
AMP 2
P21
P2
P1
PB9 P11 PB16 CAN CAN ACS CONFIG ACS CONFIG SW1 P7
ON by Honeywell DISABLE H DISABLE BATT
ON XX/XX/XX EMIC 0V P6
1 2 3 4 5 6 7 8 ENABLE 0V Tx Rx L ENABLE POWER
P9 RESET SUPPLY
OFF