Travis Industries Pro Builder Linear Quick Start Manual

Pro Builder Linear Fireplace (MV & GSB2)
The Pro Builder Linear has several new characteristics that require special attention during installation. Refer to the manual
for full details.
The Screen and Decorative Trim are One Assembly and Come With The Fireplace.
This fireplace uses a newly designed screen barrier. Make sure to remove the barrier prior to removing the glass frame.
1. Open the control door at the bottom of the assembly. Lift the assembly up slightly and tilt the top toward you. Remove
the concealment cover and place aside. It has two holes that aid in removal.
2. Remove the glass frame following the directions below.
Install The Blowers First (if Applicable). SKU# 99000194
If a blower is being used it is best to install the blower before the fireplace is installed. The blower is best installed
by removing the front cover. This must be done before the fireplace facing (tile, etc.) is placed over the front of
the fireplace. If the facing has been installed, the blower may be installed by removing the burner then removing
the two access plates on the firebox floor.
Page 1 of 2
Cheat Sheet
17601972 Printed 7/26/17