Troubleshooting - Park DT-814175 Owner's Manual

SHARPENING WEDGE SHARPENING WEDGE
SHARPENING WEDGE SHARPENING WEDGE
After using the log splitters for some
time, sharpen the wedge of the log
TROUBLE SHOOTING TROUBLE SHOOTING
TROUBLE SHOOTING TROUBLE SHOOTING
PROBLEM PROBLEM PROBLEM PROBLEM
Fails to split
logs
The log pusher
moves jerkily,
taking
unfamiliar
noise or
vibrating a lot
Oil leaks
around
cylinder ram or
from other
points.
12
PROBABLE CAUSE PROBABLE CAUSE PROBABLE CAUSE PROBABLE CAUSE
Log is improperly positioned
The sizes or hardness of the
log exceeds the capacity of
the machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized
was made on
Pressure Limiting
Lower max pressure rating
was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in
system while operating.
Bleed Screw is not tightened
before moving
splitter.
Oil Drain Bolt with Dipstick
is not tight.
Hydraulic Control
Assembly and / or seal(s)
worn
splitter using a fine-toothed file and
smooth any burrs or crushed area along
the cutting edge.
REMEDY SUGGESTED REMEDY SUGGESTED REMEDY SUGGESTED REMEDY SUGGESTED
Refer to " Log Splitter Operation"
section for perfect log loading.
Reduce
splitting it on the log splitter
Refer to " Sharpening Wedge
" section to sharpen the cutting
edge.
Locate leak(s) and contact the
dealer
adjustment
Max.
Screw. Contact the dealer.
Check oil level for possible oil
refilling.
Contact the dealer.
Loosen Bleed Screw by 3 ~ 4
hydraulic
rotations before operating the log
splitter
Tighten the Bleed Screw up before
the log
moving the log splitter.
Tighten the Oil Drain Bolt with
Dipstick.
Valve
Contact the dealer
the log sizes before