Table of Contents
Advertisement
ACE RELIANCE SENSOR OPERATIONS MANUAL
Figure 26. Correct location of the compressed assembly of the ferrule and the cone
5.5 If you observe that the compressed ferrule the cone is situated on the stainless-steel tubing of the TEC cable it
means the cable was stripped correctly. Insert the cable into the heads of the sensor. Tighten the nut finger
tight and then apply 1 ¼" turns with a 9/16" wrench.
WARNING: DO NOT OVERTIGHTEN AS IT CAN DEFORM THE CONE
Figure 27
5.6 You can use a Swagelok gap inspection gage (p/n:
MS-IG-400)
to ensure the nut is tightened properly.
V2.4
16 |
P a g e
Advertisement
Table of Contents
