Berger & Schroter 32134 User Manual page 65

Problems Potential cause
The camera Camera Settings, the PIR interval is
consumes a lot too short
of power
Camera Settings, the PIR sensitivity
is too high
Camera Settings, the IR brightness
is too high
Camera Settings, the video length is
too long
Camera Settings, the capture series
is more
More photos and videos are taken
at night
The above parameters are the balance between the camera performance and the battery life.
Users can make reasonable adjustments according to the manual and personal requirements
to obtain a reasonable effect and battery life.
The camera The waterproof ring falls off or there
leaks or fogs is foreign matter on the waterproof
ring
The lock is not fastened pro- perly or
the waterproof glue plug of the ex-
ternal power supply is not fastened
properly
Incorrect use, such as putting the
camera in water
Install or place the camera incor-
rectly, such as upside down
The camera can work well when it rains. If the camera is foggy or flooded but working
normally, please immediately shut down and remove the battery. Dry all the water or fog
with a dry towel, then open the camera lid and stand upright in a ventilated place, then use
the camera after fully dry.
Solutions
The PIR interval can be lengthened appropriately t
extend the battery life
The PIR sensitivity can be reduced appropriately to
extend the battery life
The IR brightness can be reduced to extend the
battery life
Set a shorter video length (such as 5 seconds) to
extend the battery life
Set a low number of capture series (such as 1) to
extend the battery life
The night infrared light consumes a lot of electricity.
If more photos or videos are taken at night, it is
recommended to use external power supply
Check the waterproof ring, keep the waterproof
ring clean, the waterproof ring can not be pop-up,
upturned
Before the camera works normally, all lock
fasteners must be fastened, waterproof glue plug
must be plugged, and carefully checked
Cameras can keep out the rain, but never put in
water
Install and place the camera properly. The head of
the camera must be up and as vertical as possible.
When installed close to the ground, make sure the
bottom of the camera is more than 20CM above
the ground
65