Use The Adaptor; Connect To Pc - Berger & Schroter 32134 User Manual

2.3 Use the adaptor

The camera also can be powered by adaptor as external power supply, see steps
as below:
2.3.1 Install AA batteries, set all parameters, push the (Slide) key to "ON" gear,
close the housing of camera.
2.3.2 Take down the waterproof rubber plug of DC IN port, insert the DC plug into
the DC IN port tightly.
2.3.3 Insert the adaptor plug into the socket. After being detected, the camera
will switch to use the external power supply automatically.
Notice:
Please use the standard adaptor that marked output DC6V/2.0A. After use,
please close the DC IN port with waterproof rubber plug.

2.4 Connect to PC

The camera can be connected to PC.
users can transfer files, check photos and videos.
2.4.1 Push the (Slide) key to "TEST" gear.
2.4.2 As shown on below picture, use USB cable to connect camera and PC.
2.4.3 After connection users will see " MSDC " on camera screen and " New disk
driver " on PC display. Then it can be operated as a normal U disk on PC.
Notice:
When connecting to the computer, (Slide) key should be set to the "TEST"
position. Ensure all cables are reliably connected.
If the computer configuration does not meet the requirements, it may not work
properly when connecting the camera.
Connect one end of adaptor to
external power supply and another
and to DC-IN port
43