Table of Contents
Advertisement
Available languages
Available languages
Notice:
Do not take out the SD card when the camera is working, otherwise the SD
card might damage or lose data.
Please use brand SD card and the transfer speed should be CLASS 6(inclu-
ded) or above. Do not use poor quality SD card , otherwise the camera might
not recognize it or even can't be powered on.
2.2 Installation of battery
Use 4 or 8 pcs AA batteries to power on the camera, the following is installation
method:
2.2.1 As shown in the picture, open the latches of battery cover, then open battery
cover.
2.2.2 Install batteries according to the polarity sign on the hatch. If only use 4 pcs
batteries, please install them in the left two holes.
2.2.3 Keep the clean of battery cover, close it and then close the latches.
2.2.4 Push the (Slide) key to "TEST" to check, if the screen is power on mean the
batteries installed correctly.
Notice:
Please install batteries according to instruction, do not mix use of new and
old batteries. With only 4pcs AA batteries, the battery life will be shorter.
Incorrect batteries installation can't power on the camera and may cause
damage or accident.
After installation, please close the latches firmly in case of dust or liquid
infiltration.
1. Latch of battery cover
42
2. Please pay
attention
to the polarity of
battery and install
in the right way
3. Battery door
Advertisement
Chapters
Table of Contents
