Bunn -O-MATIC ULTRA-1 Service And Repair Manual page 26

SERVICE (cont.)
AUGER SHAFT ASSEMBLY(cont.)
Open face of seal away
from tool
Cooling Drum Seal
Seal Insertion Tool
FIG. 7 COOLING DRUM SEAL
14. Assemble motor/shaft assembly as shown in Fig.
8, then install assembly into cooling drum. Make
sure the pins do not hit the sensor board and cool-
ing drum seal is not dislodged as the shaft passes
through.
Auger Shaft Assy
FIG. 8 MOTOR/SHAFT ASSEMBLY
15. Secure motor and capacitor to the cooling drum
mounting bracket. Install rear motor cover.
P1760
Lube about 1 1/2" of shaft and
in the groove with #29563.0000
"Krytox" Lubricant
P1761
16. Refer to Hopper Installation for hopper assembly
and installation procedures. Be sure to use new
hopper/drum seal and faucet seals
17. Remove and clean condenser air filter, Fig. 10.
18. Refer to the Programming Manual, "Menu Function
Index". Scroll to menu "PM Complete?" and answer
"YES" to reset the reminder message "PM Due".
26
FIG 9
ULTRA-2 shown
FIG 10
P3682
41084 102709