Troubleshooting - EGO HT2400E Repair Manual Line

Troubleshooting

Problem
Fail to start
Soft Start Failure
Excessive vibration
The speed is decreased or
less powerful compared
with normal use.
The switch lever doesn't
return to the original
position.
Possible Cause
Main PCB or its wires are broken
The blade is jammed when some
obstruction stuck in the edge of
the blade make the blade curved
or deformed.
Motor is jammed due to foreign
objects stuck in the motor.
Gears are jammed due to broken
tooth.
Malfunction of switch levers
Main PCB is broken
Unbalance of the motor
Over-worn of the Eccentric Block
Motor is broken
Dust adhered to the switch.
Fault Position Test & Solution
PCB Assembly Replace the PCB Assembly.
Clear the obstructions or replace the
Blade Set
Blade Set
Motor Replace the Motor And Gear Assembly.
Gear Set Replace the failure gears.
Switch Levers Replace the Switch Lever.
PCB Assembly Replace the PCB Assembly.
Motor Replace the Motor And Gear Assembly.
Eccentric Block Replace the Eccentric Block.
Motor Replace the Motor And Gear Assembly.
Switch Lever Clear the dust
3