Conexión De Unidades Periféricas; Peripheral Unit Connection - Ariston GENUS PREMIUM EVO HP Installation And Servicing Instructions

instalación
Conexión de Unidades Periféricas
Para acceder a las conexiones de los periféricos, proceda de la
siguiente manera:
- desconecte la caldera de la alimentación eléctrica
- extraiga la envoltura
- gire la caja eléctrica hacia delante
- desenganchar los dos clip "a", girar hacia arriba el panel "b" para
acceder a la conexión de las periféricas
- desenroscar los dos tornillos "c" y quitar la tapa "d" del porta-
instrumento para acceder a la tarjeta electrónica.
Encontramos las conexiones para:
BUS = Conexión dispositivo modulante
TA2/FLOOR = termostato para suelo radiante o el termostato
ambiental 2 (seleccionado con el parámetro 223)
SE = Sonda externa
TNK = Termostato reserva sanitaria
SOL = Sonda solar
TA1 = Termostato ambiental 1
26
b
a
installation

Peripheral unit connection

To access peripheral unit connections carry out the following steps:
- Disconnect the boiler from the power supply
- Remove the casing by unhooking it from the instrument panel
- Rotate the control panel while pulling it forwards
- Unhook the two clips "a", rotate the cover "b" to have access to
the peripherical connections
- Unscrew the two screws "c" and remove the cover "d" of the
instrument panel to have access to the main P.C.B.
Peripheral connections:
BUS = Remote control connection (modulating device)
FLOOR/ TA2 = the underfl oor heating thermostat or the room
thermostat 2 (selected via parameter 223 - factory setting =
underfl oor heating thermostat)
SE = Outdoor sensor - OPTION
TNK = Tank temperature probe
SOL = Solar temperature probe
TA1 = Room thermostat 1
Control Remoto
Remote Control Sonda externa
External Sensor
OK
Sensys
FLOOR
T B
BUS TA2
c
d
Termostato Ambiente
Room Thermostat 1
1 2 3 4
Termostato acumulador
Tank Thermostat
SE TNK SOL TA1
5 6 7