Advertisement
D
Figure 7: Wiring
C
B
2) Wire the battery to controller:
a) Crimp a pair of #8 fork terminals provided to one end of a separate length of the 2/2 cable provided and
connect to the charge controller Battery screw terminals:
Red wire to Battery (+)
Black wire to Battery (–)
b) Route this cable either directly to the battery or if more convenient, to the line side of a power distribution
A
bus. Before connecting to vehicle battery system install the ATC in-line fuse holder provided on the red/
positive (+) wire on the battery end (as close to + battery/+ bus as practical) – do not install the ATC-15
fuse at this time. Connect the black/negative (-) wire to the battery negative (-) terminal or a convenient
ground bus point.
4
Figure 8: Battery Wiring
Optional NPT-1/2
Cord Grip
12/2 Cable
3) Once solar panel wiring preparation has been completed (see section 6A), install panel on roof, verify
protective cardboard is still taped to solar panel PVC side to prevent solar panel current from flowing during
wiring. Route the solar panel cable from the roof to the charge controller and crimp a pair of # 8 fork terminals
provided and connect to the charge controller 'Solar' panel screw terminals:
Red wire to Solar (+)
Black wire to Solar (–)
See the Morningstar Sun Savers Operators Manual for more information regarding controller operation.
P.O. Box 1306
Newport Beach
California 92663
Solar Panel
SOLAR PANEL
_
-
+
+
Controller
Fuse
FUSE
_
+
-
+
Battery
BATTERY
3
www.newmarEVpower.com
+
+ _
CONTROLLER
Solar
-
+
+
Battery
_
-
DRAWN
Roy
CHECKED
QA
MFG
APPROVED
2
15 Amp ATC Fuse
12 Volt Battery
E-Mail: techservice@newmarpower.com
5/6/2011
NEW
AR
TITLE
SOLAR80 WIRING DIAGRAM
SIZE
DWG NO
C
SCALE
1
SHEET
OF
1
8
Phone: 714-751-0488
Fax: 714-957-1621
D
C
B
A
REV
1
Advertisement
