Advertisement
seal can be swapped for wire routing convenience.
3) Observing correct polarity attach the red wire to the POSITIVE (+) screw terminal and the black wire to the
NEGATIVE (-) screw terminal. Secure both screws tightly. Tighten the cord grip fitting nut securely so it grips
the cable and provides a water tight seal around the cable.
4) Close the junction box cover and secure it with the two Philips head screws.
5) Using the provided self adhesive cable clamps, secure the cable to the rear of panel to eliminate cable
movement while the vehicle is in motion. Route cable towards cable feed thru location on roof.
B. Mounting the Solar Panel
Note: Install cable to junction box on solar panel rear before proceeding with panel installation.
Figure 4: Mounting Solar Panel
1/4"-20 Nylock Nut
1/4" Flat Washer
1/4" 20 x 5/8" M.S. Hex Head
1/4" Split Lock Washer
1/4" Flat Washer
Z Bracket
1/4" 20 x 5/8" M.S. Hex Head
* 1/4"-20 Nut Sert/Grip-N-Sert
* Additional 1/4"-20 Nylock Nuts and flat washers
provided if nut-sert is not used
Figure 4B: 120 Watt Panel
Center Mounting Holes
(six Z Brackets total)
P.O. Box 1306
Newport Beach
California 92663
If required, drill using 1/4" bit
to enlarge holes for additional
mounting
www.newmarEVpower.com
Figure 4A: Z Bracket Orientation
Z Bracket Orientation
Panel Side
Roof Side
E-Mail: techservice@newmarpower.com
5
Phone: 714-751-0488
Fax: 714-957-1621
Advertisement
