Advertisement
Available languages
Available languages
MOTOR/MAGNET INTERLOCK
The motor/magnet interlock is a feature that prevents
power from being applied to the drill motor if the
magnet is not energized.
The motor magnet interlock also prevents the magnet
from being de-energized while the motor is running.
MAINS CONNECTION
Connect only to a single-phase AC current supply and
only to the mains voltage specifi ed on the rating plate.
Must only be used from sockets with earth wire.
Pre-connect a residual current device (FI, RCD,
PRCD).
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the
machine. Always lead the cable away behind you.
MAINTENANCE
Before use check machine, cable, safety harness and
plug for any damages or material fatigue. Repairs
should only be carried out by authorised service
agents.
The ventilation slots of the machine must be kept clear
at all times.
From time to time, apply a few drops of oil to the rack
toothing. The bearings of the feed shaft are self-cutting
and must not be greased.
Grease the sliding surface of the carriage with
Molykote grease.
Clean dust and debris from tool. Keep tool handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean the tool since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Never use fl ammable or
combustible solvents around tools.
Use only Milwaukee accessories and Milwaukee spare
parts. Should components need to be replaced which
have not been described, please contact one of our
Milwaukee service agents (see our list of guarantee/
service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the Article No. as well as the machine
type printed on the label and order the drawing at your
local service agents.
SYMBOLS
CAUTION! WARNING! DANGER!
Always disconnect the plug from the socket
before carrying out any work on the machine.
Always work in pairs when using the drill
stand above head height. Carry the electric
tool between the two of you to avoid suff
ering back injuries.
20
English
Please read the instructions carefully before
starting the machine.
Always wear goggles when using the machine.
Wear ear protectors!
Wear gloves!
DANGER! To reduce the risk of injury,
always keep hands, rags, clothing, etc. away
from moving parts and chips. Do not try to
remove chips while the cutter is rotating.
Chips are sharp and can pull objects into
moving parts.
Carrying along metal parts and watches is
prohibited.
Persons with cardiac pacemakers or other
medicinal implants may not use this drill
stand.
Carrying of magnetic or electronic media
prohibited.
Never expose tool to rain.
Core hole drill bit
Solid drill bit
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the
end of their life must be collected separately
and
returned
compatible recycling facility. Check with your
local authority or retailer for recycling advice
and collection point.
Class II tool. Tool in which protection
against electric shock does not rely on basic
insulation only, but in which additional safety
precautions, such as double insulation or
reinforced insulation, are provided. There
being no provision for protective earthing or
reliance upon installation conditions.
18
to
an
environmentally
Advertisement
