Related Manuals for Milwaukee M18 CDD
Summary of Contents for Milwaukee M18 CDD
- Page 1 OPERATOR'S MANUAL Cat. No. M18 CDD M18 CPD M18™ CORDLESS 13mm (1/2") DRILL/DRIVER AND HAMMER DRILL/DRIVER TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.
-
Page 2: Work Area Safety
GENERAL POWER TOOL SAFETY WARNINGS WARNING READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS. Save all warnings and instructions for future reference. attached to a rotating part of the power tool may WORK AREA SAFETY result in personal injury. Cluttered or dark areas invite accidents. -
Page 3: Specifications
2. Control switch SPECIFICATIONS 3. LED Cat. No. DC No Load RPM 4. Keyless chuck M18 CDD Low 0 - 550 5. Torque selector collar High 0 - 1 850 6. Application selector collar M18 CPD Low 0 - 550 Low 0 - 9350 7. -
Page 4: Operation
Reposition WARNING and tighten securely. OPERATION WARNING (Cat. No. M18 CDD) rotate the torque selector collar until the drill symbol appears in line with the arrow. rotate WARNING... - Page 5 WARNING rotate the application selector col- lar until the drive symbol pears in line with the arrow. Then rotate the torque selector collar 1. To until the desired clutch setting ap- pull the trigger. pears in line with the arrow. NOTE: An LED is turned on when the trigger is The adjustable clutch, when properly adjusted, pulled.
-
Page 6: Maintenance
MAINTENANCE APPLICATIONS WARNING WARNING n authorised MILWAUKEE dealer for ALL When drilling in wood, composition materials and plastic, select the drill-only operating mode. Start the drill slowly, gradually increasing speed as Keep your tool, battery pack and charger in good re- you drill. - Page 7 Techtronic Industries (Australia) Pty. Ltd. Doncaster, Victoria, Australia, 3108 Milwaukee Electric Tool Corporation (New Zealand) Techtronic Industries (New Zealand) Pty. Ltd. Penrose, Auckland, New Zealand, 1060 Printed in China Professionally made in China for Milwaukee Electric Tool Corporation 961067701-01(A) 58-14-2604d1...