Programming The Dispenser - Bunn LCA-2 LP Installation And Operating Manual

Open the dispenser door to access the digital programming module with LED display.
Two basic modes are available to the operator: Display Mode and Program Mode.
To enter the Display Mode, Set the RUN/NIGHT/PROGRAM Switch to the RUN position.
To enter the Program Mode, Set the RUN/NIGHT/PROGRAM Switch to the PROGRAM position.
Display Mode: Used to view the current set-up values. Use the MENU switch to scroll to the next display.
NOTE: The display blanks out after two minutes of inactivity. Press any button to activate the display.
LCD DISPLAY
1 8 0
MENU (-)
0 1 1 8 0
MENU (-)
0 2 3
MENU (-)
3
0 3
MENU (-)
0 4 0. 0
MENU (-)
0 5 0. 0
MENU (-)

PROGRAMMING THE DISPENSER

DISPLAY MODE
Home View
(+)
Tank Temperature
(+)
0
Regular Dispense Ratio
(+)
0
Decaf Dispense Ratio
(+)
Cup Dispense Volume
(+)
Carafe Dispense Volume
(+)
DESCRIPTION
DisplaysTank Temperature.
Displays target Tank Temperature (F°)
Displays Left Dispense Ratio (XXX:1)
Displays Right Dispense Ratio (XXX:1)
Displays Cup Dispense Volume (XX.X
Oz.). Set to 0.0 for "Push and Hold"
Dispense Mode.
Displays Carafe Dispense Volume
(XX.X Oz.)
12
38791 072307